While watching the inside Schlage button, reconnect the battery connector.Verify Z-Wave connection status from the lock A √ indicates the lock successfully joined the Z-Wave network, while an X indicates that it did not successfully join the network.From the Hubitat Web Interface home page, select Z-Wave, then Start Z-Wave Pairing on the Device Discovery page.If the reset was successful, the lock will perform a setup routine.To check that the lock was reset, press the outside Schlage button and enter one of the Default User Codes.
#SCHLAGE KEYPAD LOCK TROUBLESHOOTING CODE#
If you want to use a specific code to trigger a rule machine rule it must be programmed through the Lock Code Manager or the Locks device page NOT the lock itself. Any code (including the 2 default codes) that are programmed into the lock directly, Lock Code Manager will not be able to read or identify those codes, they will appear as ? on your lock’s device page.After it’s successful, under your Device Details page the “State Variables” should say “fetch Code: 30” and “codeFetchComplete 1” If it does not then you need to click the “get codes” tab, and re-verify the logs. Another good tip is during the inclusion of the Schlage Lock, it is a really good idea to have a separate browser tab open to the “logs” page, and make sure the lock completes the configure process, and by make sure I mean WAIT until all 30 lock codes are “fetched” in the logs BEFORE doing anything else on the hub (sometimes this can take a minute or two), sometimes other device traffic can interrupt this process.Make sure under your “settings” “zwave details” page up at the top right where it says “secure/join” this is set to “Locks/Garage Doors” and NOT ALL Secure Z-wave .Here are a few Hubitat tips not provided in the video:
For Hubitat users, it is also recommended that you watch this video:
It is recommended that you have one near the lock and one near the hub. Normal non-beaming repeaters (certain in-wall switches, etc.) will be no help.
#SCHLAGE KEYPAD LOCK TROUBLESHOOTING SERIES#
If you are experiencing problems pairing the lock or with the lock updating in Hubitat Elevation C-5 series hubs, it is likely that you will need an Aeotec Range Extender 6 or some other Range Extender with Beaming Technology. Schlage Connect Deadbolt Models BE468 & BE469
0 kommentar(er)
